Traduction de «lunette de mesure d'angle » (Français → Anglais) :

review the achievement of the objectives of all the measures (at the level of results and impacts), the state of play regarding the implementation of the eligible actions set out in Article 4 and the specific actions referred to in Annex I, the allocation of funds to the beneficiaries in accordance with the conditions set in Article 5, the efficiency of the use of resources and its European added value, taking into consideration developments in the area of consumer protection, with a view to a decision on the renewal, modification or suspension of the measures.

‘Actual torso angle’ means the angle measured between a vertical line through the ‘H’ point and the torso line using the back angle quadrant on the 3-D H machine. The actual torso angle corresponds theoretically to the design torso angle (for tolerances see paragraph 3.2.2 below):

If the results of at least two of the three operations described in paragraph 3.2.4 above do not satisfy the requirements of paragraph 3.2.2 above, or if the verification cannot take place because the vehicle manufacturer has failed to supply information regarding the position of the ‘R’ point or regarding the design torso angle, the centroid of the three measured points or the average of the three measured angles shall be used and be regarded as applicable in all cases where the ‘R’ point or the design torso angle is referred to in this Regulation.

The findings of these projects should prove invaluable, in both policy and operational terms, for the development of policy on the enhancement of the protection capacity of the regions or origin, and for developing strategies for measuring effective protection.

Their constituent elements would be as far as possible measurable, practical actions that would deliver real benefits both in terms of protection offered and in terms of their impact within existing arrangements with the third country.

Whereas activities in respect of sight testing carried out by opticians with a view to the manufacture of lenses for spectacles are excluded from the scope of the Council Directive of 7 July 1964 (5) concerning the attainment of freedom of establishment and freedom to provide services in respect of activities of self-employed persons in manufacturing and processing industries falling within ISIC Major Groups 23-40 (Industry and small craft industries) ; whereas consequently the Directive (6) laying down detailed provisions concerning transitional measures in respect of such activities should likewise not apply to those activities;