Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Angle critique
Angle de dégagement apparent
Angle de dégagement mesuré
Angle de dépouille apparent
Angle de dépouille mesuré
Angle de détalonnage apparent
Angle de détalonnage mesuré
Angle de réflexion limite
Angle de réflexion totale
Angle extérieur
Angle limite
Angle limite d'incidence
Angle limite de réflexion totale
Angle saillant
Courbe convexe
Courbe de point haut
Courbe saillante
Courbe verticale saillante
Faits marquants
Faits saillants
Points saillants
Ruban à fibres saillantes
Saillant

Traduction de «angle saillant » (Français → Anglais) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous




angle extérieur | angle saillant

capping with extended return | quoin


Statistiques sur les tribunaux de la jeunesse : Faits saillants de 1994-1995 [ Statistiques sur les tribunaux de la jeunesse : Faits saillants de 1991-1992 ]

Youth Court Statistics 1994-95: Highlights [ Youth Court Statistics 1991-92: Highlights ]


faits saillants | points saillants | faits marquants

highlights | financial highlights | selected financial data


courbe de point haut [ courbe verticale saillante | courbe saillante | courbe convexe ]

crest vertical curve [ crest curve | summit curve ]


angle de dépouille mesuré | angle de dépouille apparent | angle de dégagement mesuré | angle de dégagement apparent | angle de détalonnage mesuré | angle de détalonnage apparent

measured lip clearance angle | lip relief angle | backing off | lip clearance angle


angle limite de réflexion totale | angle critique | angle de réflexion totale | angle de réflexion limite | angle limite d'incidence | angle limite

critical angle | angle of total reflection




TRADUCTIONS EN CONTEXTE
le bord supérieur. La position du centre de gravité du mouton se situe à un sixième de la largeur du sommet du dispositif de protection à l'intérieur d'un plan vertical parallèle au plan médian du tracteur touchant l'extrémité supérieure du sommet de dispositif de protection.Si le dispositif est courbe ou saillant en ce point, des coins doivent être ajoutés pour que le choc ait lieu en ce point, sans que cela se traduise par un renforcement du dispositif.1.2.2.Le tracteur doit être ancré au sol au moyen de quatre câbles, disposés chacun à une extrémité des deux essieux, conformément aux indications de la figure 6 de l'annexe IV. Les poi ...[+++]

Annex II A.With the wire ropes tensioned, the wedging beam shall be placed firmly behind the rear wheels and then fixed to the ground.1.2.3.If the tractor is of the articulated type, the point of articulation shall in addition be supported by a wooden block at least 100 mm square and firmly lashed to the ground.1.2.4.The pendulum block shall be pulled back so that the height of its centre of gravity above that at the point of impact is given by one of the following two formulae, to be chosen according to the reference mass of the tractors subjected to the tests:H = 25 + 0,07 mt for tractors with a reference mass of less than 2 000 kilograms,H = 125 + 0,02 mt for tractors with a reference mass of more than 2 000 kilograms.The pendulum block ...[+++]


La position du centre de gravité du mouton se situe à un sixième de la largeur du sommet du dispositif de protection à l'intérieur d'un plan vertical parallèle au plan médian du tracteur touchant l'extrémité supérieure du sommet du dispositif de protection.Si le dispositif est courbe ou saillant en ce point, des coins doivent être ajoutés pour que l'impact ait lieu en ce point, sans que cela se traduise par un renforcement du dispositif.1.1.2.Le tracteur doit être ancré au sol au moyen de quatre câbles disposés chacun à une extrémité des deux essieux conformément aux indications de la figure 5 de l'annexe IV. Les points d'ancrage avant ...[+++]

The position of the centre of gravity of the block shall be one-sixth of the width of the top of the protection structure inwards from a vertical plane parallel to the median plane of the tractor touching the outside extremity of the top of the protection structure.If the structure is curved or protruding at this point, wedges enabling the impact to be applied thereon will have to be added, without thereby reinforcing the structure.1.1.2.The tractor shall be lashed to the ground by means of four wire ropes, one at each end of both axles, arranged as indicated in Figure 5 of Annex IV. The front and rear lashing points shall be located at a distance such that the wire ropes make an angle ...[+++]


w