Traduction de «Cycling speed » (Anglais → Français) :

pressing cycle speed [ press cycle speed ]

pressing cycle speed

speed control [ maximum speed | minimum speed | speed limit | tachograph | Driving speed(STW) | speed limitation(UNBIS) ]

speed-changing mechanism | speed-change mecanism | speed-change | change speed | variable speed transmission | variable-speed drive | variable gear | speed-changing device | variable transmission

high-speed transport [ high speed | high-speed train | rapid-transit railway | high-speed train(GEMET) ]

economic fluctuation [ business cycles(UNBIS) ]

7. In the case of an engine of category IWP intended to be used for both variable-speed and constant-speed operation, the requirements of paragraph 5 shall be fulfilled for each applicable steady-state test cycle separately and the information document shall indicate each steady-state test cycle in respect of which those requirements were fulfilled.

Except in the cases referred to in paragraphs 7 and 8, a variable-speed engine of a particular category used in a constant-speed operation of the same category need not be tested using the applicable constant-speed steady-state test cycle.

EUROPA - EU law and publications - EUR-Lex - EUR-Lex - 32008R0692 - EN - Commission Regulation (EC) No 692/2008 of 18 July 2008 implementing and amending Regulation (EC) No 715/2007 of the European Parliament and of the Council on type-approval of motor vehicles with respect to emissions from light passenger and commercial vehicles (Euro 5 and Euro 6) and on access to vehicle repair and maintenance information (Text with EEA relevance) - COMMISSION REGULATION - (EC) No 692/2008 // of 18 July 2008 // implementing and amending Regulation (EC) No 715/2007 of the European Parliament and of the Council on type-approval of motor vehicles with respect to emissions from light passenger and commercial vehicles (Euro 5 and Euro 6) and on access to ve ...[+++]hicle repair and maintenance information // ADMINISTRATIVE PROVISIONS FOR EC TYPE-APPROVAL // Appendix 1 // Verification of conformity of production — First statistical method // Appendix 2 // Verification of conformity of production — Second statistical method // Appendix 3 // MODEL // INFORMATION DOCUMENT No . // Appendix to information document // INFORMATION ON TEST CONDITIONS // Appendix 4 // MODEL OF EC TYPE-APPROVAL CERTIFICATE // (Maximum format: A4 (210 × 297 mm)) // Addendum to EC type-approval certificate No . // concerning the type-approval of a vehicle with regard to emissions and access to vehicle repair and maintenance information according to Regulation (EC) No 715/2007 // Appendix 5 // Vehicle OBD information // Appendix 6 // EC Type –Approval Certification Numbering System // Appendix 7 // IN-SERVICE CONFORMITY // IN-SERVICE CONFORMITY CHECK // STATISTICAL PROCEDURE FOR IN-SERVICE CONFORMITY TESTING // RESPONSIBILITIES FOR IN-SERVICE CONFORMITY // VERIFYING AVERAGE EXHAUST EMISSIONS AT AMBIENT CONDITIONS // (TYPE 1 TEST) // EMISSIONS DATA REQUIRED AT TYPE-APPROVAL FOR ROADWORTHINESS PURPOSES // MEASURING CARBON MONOXIDE EMISSION AT IDLING SPEEDS // (TYPE 2 TEST) // MEASUREMENT OF SMOKE OPACITY // VERIFYING EMISSI ...

‘steady-state test cycle’ means a test cycle in which engine speed and torque are held at a finite set of nominally constant values; steady-state tests are either discrete mode tests or ramped-modal tests.