Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Back rest angle
Back-rake angle
Design position of the seat back
Design seat-back angle
Design torso angle
Seat back angle
Seat back rake angle

Traduction de «Seat back rake angle » (Anglais → Français) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
back rest angle | seat back rake angle

angle de dossier | angle d'inclinaison du dossier


back-rake angle

angle de pente arrière [ angle d'inclinaison arrière ]


design position of the seat back | design seat-back angle

inclinaison prévue du dossier


design torso angle | seat back angle

angle prévu de torse
TRADUCTIONS EN CONTEXTE
Where there are other possibilities for adjusting the seat (vertical, angled, seat back, etc.) the adjusted positions shall be as specified by the vehicle manufacturer.

Lorsqu’il existe d’autres possibilités de réglage des sièges (verticalité, inclinaison, dossier, etc.), les réglages de leur position sont ceux spécifiés par le constructeur du véhicule.


(d) limit the rotation of the head of the anthropomorphic test device toward the rear of the restraint system or booster seat, in the head’s midsagittal plane, by means of a continuous seat back that is an integral part of the restraint system or booster seat, so that the angle between the head and the torso is at no time during the test more than 45° as compared to the angle between the head and the torso immediately before the te ...[+++]

d) ils limitent, au moyen d’un dossier continu qui fait partie intégrante de l’ensemble ou du siège d’appoint, la rotation de la tête du dispositif anthropomorphe d’essai vers l’arrière de l’ensemble ou du siège d’appoint, dans le plan mi-sagittal de la tête, de manière que l’angle entre la tête et le torse ne soit, à aucun moment au cours de l’essai, supérieur à 45° par rapport à l’angle entre la tête et le torse immédiatement avant le début de l’essai;


(b) the torso line of the template is at the same angle to the vertical plane as the vehicle seat back with the seat adjusted to its full rearward and full downward position and the seat back in its most upright position; and

b) dont la ligne de torse forme le même angle, par rapport au plan vertical, que le dossier du siège lorsque le siège se trouve dans sa position la plus reculée et la plus basse et le dossier, dans sa position la plus droite;


(b) the torso line of the template is at the same angle to the vertical plane as the seat back with the seat adjusted to its full rearward and full downward position and the seat back in its most upright position.

b) d’autre part, la ligne du torse forme le même angle, par rapport à la verticale, que le dossier du siège lorsque le siège se trouve dans sa position la plus reculée et la plus basse et le dossier, dans sa position la plus droite.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
(18) Subject to subsections (19) and (20), if a lower universal anchorage system is not visible along a line making an upward angle of at least 30° with the horizontal plane without compression of the seat cushion or seat back of the seating position, the presence of each bar of the system shall be indicated by the symbol shown in Figure 10, consisting of a circle containing a pictogram, which symbol shall meet the following conditions:

(18) Sous réserve des paragraphes (19) et (20), si le dispositif universel d’ancrages d’attaches inférieurs n’est pas visible le long d’une ligne située au-dessus de la ligne horizontale et formant avec celle-ci un angle de 30° ou plus, sans qu’il soit nécessaire de comprimer ni le coussin ni le dossier du siège de la place assise, la présence de chacune de ses barres est indiquée au moyen d’un symbole constitué d’un pictogramme sur un cercle, lequel est illustré à la figure 10 et est conforme aux conditions suivantes :


(f) in the case of a restraint system other than a car bed, limit the rotation of the head of the anthropomorphic test device towards the rear of the restraint system, in its midsagittal plane, by means of a continuous seat back that is an integral part of the restraint system, so that the angle between the head and the torso is at no time during the test more than 45° as compared to the angle between the head and the torso prior t ...[+++]

f) doit, dans le cas d’un ensemble de retenue autre qu’un lit d’auto, limiter la rotation de la tête du dispositif anthropomorphe d’essai vers l’arrière de l’ensemble de retenue, dans le plan mi-sagittal, au moyen d’un dossier continu qui fait partie intégrante de l’ensemble de retenue, de manière que l’angle entre la tête et le torse ne soit, à aucun moment au cours de l’essai, supérieur à 45° par rapport à l’angle entre la tête et le torse avant l’essai;


the seat back, if adjustable, shall be adjusted as to accommodate the three-dimensional H-point machine at a torso angle of 25 degrees.

le dossier, s'il est réglable, est réglé de façon à recevoir la machine tridimensionnelle point H à un angle de torse de 25 degrés.


Table 1 contains the basic coordinates for an intended seat back rake angle of 25o.

Le tableau 1 indique les coordonnées de base pour un angle prévu d'inclinaison du dossier de 25o.


2.2. When a H point and a true backrest rake angle is being determined, the seat in question is placed in the rearmost normal position provided by the manufacturer for driving or travelling, the back, if adjustable, being locked in a position specified by the manufacturer or, in the absence of any specification, in a manner such that the real rake angle is between 25° and 15°.

2.2. Pour chaque détermination du point «H» et de l'«angle réel d'inclinaison du dossier», le siège considéré est placé dans la position de conduite ou d'utilisation normale la plus basse et la plus reculée prévue pour ce siège par le constructeur. Le dossier, s'il est réglable, est verrouillé dans la position spécifiée par le constructeur ou, en l'absence de spécification, de telle façon que l'angle réel d'inclinaison soit compris entre 25 et 15°.


6.2. The check on the relative position of the R and H points and on the relationship between the intended angle and true backrest rake angle is considered satisfactory for the seating position under consideration if the H point as defined by its coordinates is located within a 50 mm square having a centre R and if the true backrest rake angle does not diverge by more than 5° from the intended rake angle.

6.2. La vérification de la position relative des points «R» et «H» et du rapport entre l'angle prévu et l'angle réel d'inclinaison du dossier est considérée comme satisfaisante pour la place assise considérée si le point «H», tel qu'il est défini par ses coordonnées, se situe dans un carré de centre «R» dont le côté est 50 mm, et si l'angle réel d'inclinaison du dossier ne s'écarte pas de plus de 5° de l'angle prévu d'inclinaison.




D'autres ont cherché : back rest angle     back-rake angle     design seat-back angle     design torso angle     seat back angle     seat back rake angle     Seat back rake angle     


datacenter (1): www.wordscope.ca (v4.0.br)

'Seat back rake angle' ->

Date index: 2021-06-05
w