Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Conical end
Conical end needle roller
Conical end of an electrode
Conical end screw
Double-ended conical churn
Pointed tip
Striking end

Traduction de «conical end an electrode » (Anglais → Français) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
conical end of an electrode | pointed tip

extremite d electrode conique


conical, with inverted conical end symmetrical

tronconique inversée tronconique symétrique


inverted, conical, truncated symmetrical double edged wax scraper with truncated conical end

grattoir à cire tronconico-tronconique inversé à deux tranchants




conical end needle roller

aiguille à extrémités tronconiques




covering chamfered at the end of an electrode to facilitate striking | striking end(of an electrode)

dénudation pour l'amorçage(de l'électrode


TRADUCTIONS EN CONTEXTE
The electrical conductivity of a column of liquid defined by two parallel platinum electrodes at its ends is measured by incorporating it in one arm of a Wheatstone bridge.

Mesure de la conductivité électrique d’une colonne de liquide, délimitée par deux électrodes de platine maintenues parallèles, constituant l’une des branches d’un pont de Wheatstone.


(a) the No. 1 post shall be at least four feet above the surface of the ground located at the upstream end of the area to be covered by the lease and shall be a post not less than four inches in diameter, mounded to a height of two feet, such mounding to be conically shaped and having a diameter at the base of not less than three feet, and this post shall be faced on the downstream side, which facing shall contain the following inscription legibly marked thereon:

a) la borne n 1 placée à l’extrémité d’amont de l’étendue qui doit être visée par le bail doit s’élever d’au moins quatre pieds au-dessus du niveau du sol, et elle doit consister en un poteau d’au moins quatre pouces de diamètre, butté jusqu’à une hauteur de deux pieds, ce buttage devant être conique et avoir à sa base un diamètre d’au moins trois pieds; ce poteau doit être aplati du côté aval, la partie ainsi aplatie devant porter l’inscription ci-dessous, lisiblement marquée :


Immerse the silver electrode (4.1) and the free end of the bridge (4.2) in the solution. Connect the electrodes to the potentiometer (4.1) and, after verifying the zero of the apparatus, note the value of the starting potential.

Plonger l'électrode en argent (4.1.) et l'extrémité libre du pont (4.2.) dans la solution, raccorder les électrodes au potentiomètre (4.1.) et, après avoir vérifié le zéro de l'appareil, noter la valeur du potentiel de départ.


Immerse the silver electrode (4.1) and the free end of the bridge (4.2) in the solution. Connect the electrodes to the potentiometer (4.1) and, after verifying the zero of the apparatus, note the value of the starting potential.

Plonger l'électrode en argent (4.1) et l'extrémité libre du pont (4.2) dans la solution, raccorder les électrodes au potentiomètre (4.1) et, après avoir vérifié le zéro de l'appareil, noter la valeur du potentiel de départ.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
Immerse the silver electrode (4.1) and the free end of the bridge (4.2) in the solution. Connect the electrodes to the potentiometer (4.1) and, after verifying the zero of the apparatus, note the value of the starting potential.

Plonger l'électrode en argent (4.1) et l'extrémité libre du pont (4.2) dans la solution, raccorder les électrodes au potentiomètre (4.1) et, après avoir vérifié le zéro de l'appareil, noter la valeur du potentiel de départ.


Immerse the silver electrode (4.1) and the free end of the bridge (4.2) in the solution, connect the electrodes to the potentiometer (4.1) and, after having verified the zero of the apparatus, note the value of the starting potential.

Plonger l'électrode en argent (4.1) ainsi que l'extrémité libre du pont (4.2) dans la solution, raccorder les électrodes au potentiomètre (4.1). Après avoir vérifié le zéro de l'appareil, noter la valeur du potentiel de départ.


Immerse the silver electrode (4.1) and the free end of the bridge (4.2) in the solution, connect the electrodes to the potentiometer (4.1) and, after having verified the zero of the apparatus, note the value of the starting potential.

Plonger l'électrode en argent (4.1) ainsi que l'extrémité libre du pont (4.2) dans la solution, raccorder les électrodes au potentiomètre (4.1). Après avoir vérifié le zéro de l'appareil, noter la valeur du potentiel de départ.


4.2. Bridge, containing a saturated potassium nitrate solution, connected to the calomel electrode (4.1), fitted at the ends with porous plugs.

4.2. Un pont contenant une solution saturée de nitrate de potassium connecté à l'électrode au calomel (4.1), fixé aux extrémités par des bouchons poreux.


After cooling, dilute with 50 ml of water and cool further; place this liquid in the bubbler B via filter E; next add 40 to 50 ml of 30 % sodium hydroxide, to obtain full alkalinization of the liquid and drive off the ammonia with the steam, collecting the distillate in 5 ml of boric acid solution placed in advance in the conical receiver flask with 10 ml of water, with the end of the bulb immersed in the liquid.

Après refroidissement, diluer avec 50 ml d'eau et refroidir; introduire ce liquide dans le barboteur B par l'entonnoir E; ajouter ensuite 40 à 50 ml de lessive de soude à 30 %, de manière à obtenir l'alcalinisation franche du liquide et entraîner l'ammoniac par la vapeur en recueillant le distillat dans 5 ml de solution d'acide borique placés préalablement dans la fiole conique réceptrice avec 10 ml d'eau, l'extrémité de l'ampoule plongeant dans le liquide.


After an appropriate quantity of aerosol product has been taken into the transfer bottle, fit the conical end of the syringe to the transfer bottle as described in 5.4.2.2.

Après avoir transvasé une quantité appropriée du produit dans le flacon de transfert au moyen de la pièce de transfert, adapter la seringue sur le flacon transfert comme indiqué en 5.4.2.2.




datacenter (1): www.wordscope.ca (v4.0.br)

'conical end an electrode' ->

Date index: 2021-04-15
w