Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Screen with horizontal edge
Screen with vertical edge
Vertical blanking synchronization
Vertical screen partitioning
Vertical screen split

Translation of "screen with vertical edge " (English → French) :

TERMINOLOGY
see also In-Context Translations below


vertical screen partitioning | vertical screen split

division verticale de l'écran | partage vertical de l'écran | partition verticale de l'écran




vertical blanking synchronization [ Synchronizing a display to the vertical blank interval will provide smooth animation with no screen glitches. ]

synchronisation verticale [ synchronisation d'intervalles verticaux ]
IN-CONTEXT TRANSLATIONS
the two vertical planes touching the two lateral edges of the plate and forming an angle measured outwards to the left and to the right of the plate of 30° in relation to the longitudinal plane, parallel to the longitudinal median plane of the vehicle, passing through the centre of the plate,

les deux plans verticaux passant par les deux bords latéraux de la plaque et formant un angle vers la gauche et vers la droite de la plaque de 30° par rapport au plan longitudinal, parallèle au plan médian longitudinal du véhicule, passant par le centre de la plaque,


To determine the lower, upper and lateral limits of the illuminating surface only screens with horizontal or vertical edges shall be used to verify the distance to the extreme edges of the vehicle and the height above the ground.

pour déterminer les bords inférieurs, supérieurs et latéraux de la plage éclairante, on considère seulement des écrans à bords horizontaux ou verticaux, de façon à vérifier la distance jusqu’aux extrémités du véhicule et la hauteur au-dessus du sol.


Internal steps for external access shall have a minimum depth of 240 mm between the vertical edges of the step and a maximum height of 200 mm. The height of each step may be increased to a maximum of 230 mm if it can be demonstrated that this achieves a reduction of one in the total number of steps required.

Les marches intérieures d'accès extérieur doivent avoir une profondeur minimale de 240 mm mesurée entre les bords verticaux de la marche et une hauteur maximale de 200 mm. La hauteur de chaque marche peut être portée à un maximum de 230 mm s'il peut être démontré que cette mesure permet de réduire d'une unité le nombre de marches nécessaires.


There shall also be a clear space between the front edge of the seat cushion and the same vertical plane for the seat in front of a minimum of 230 mm.

Un espace libre minimal de 230 mm doit également exister entre le bord avant de l'assise du siège et le plan vertical passant par la partie la plus à l'arrière du siège précédent.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
(ii) no point on a longitudinal vertical plane tangent to the outboard side of the seat cushion is less than 254 mm from the innermost point on the inside surface of the door, which point is situated vertically between the H-point and shoulder reference point of the template and longitudinally between the front edge of the cushion with the seat adjusted to its forwardmost position and the rear edge of the cushion ...[+++]

(ii) aucun point du plan longitudinal vertical tangent à l’extrémité extérieure du côté du coussin n’est à moins de 254 mm du point se trouvant le plus à l’intérieur sur la surface intérieure de la porte, lequel point est situé verticalement entre le point H et le point de référence de l’épaule du gabarit et longitudinalement entre le bord avant du siège, réglé dans sa position la plus avancée, et le bord arrière du siège, réglé dans sa position la plus reculée, tel qu’illustré par la figure.


The space for mounting the plate must be visible within a space bordered by two dihedrals: one with a horizontal edge defined by two planes passing through the upper and lower horizontal edges of the space for mounting the plate, the angles of which in relation to the horizontal are shown in Figure 1; the other with a perceptibly vertical edge defined by two planes passing through each side of the plate, the angles of which in rel ...[+++]

La visibilité de l’emplacement pour le montage de la plaque d’immatriculation doit être assurée à l’intérieur d’un espace délimité par deux dièdres: l’un avec une arête horizontale et défini par deux plans qui passent par les bords horizontaux supérieurs et inférieurs de l’emplacement pour le montage de la plaque et dont les angles par rapport à l’horizontale sont indiqués sur la figure 1, l’autre avec une arête sensiblement verticale et défini par deux plans qui passent par les bords latéraux de la plaque et dont les angles par rapport au plan longitudinal médian du véhicule sont indiqués sur la figure 2.


1.2. ‘bonnet leading edge reference line’ means the geometric trace of the points of contact between a straight edge 1 000 mm long and the front surface of the bonnet, when the straight edge, held parallel to the vertical longitudinal plane of the vehicle and inclined rearwards by 50 ° and with the lower end 600 mm above the ground, is traversed across and in contact with the bonnet leading edge.

1.2. «ligne de référence du bord avant du capot», la trace géométrique des points de contact entre une ligne droite de 1 000 mm de long et la face antérieure du capot, lorsque la ligne droite, maintenue parallèlement au plan longitudinal vertical du véhicule et inclinée de 50° vers l’arrière, l’extrémité inférieure étant située à 600 mm au-dessus du sol, est déplacée à travers et contre le bord avant du capot.


To determine the lower, upper and lateral limits of the illuminating surface, only screens with horizontal or vertical edges shall be used.

Pour déterminer les bords inférieur, supérieur et latéraux de la plage éclairante, on considère seulement des écrans à bord horizontal ou vertical.


To determine the lower, upper and lateral limits of the illuminating surface, only screens with horizontal or vertical edges shall be used.

Pour déterminer les bords inférieur, supérieur et latéraux du feu, on considère seulement des écrans à bord horizontal ou vertical.


To determine the lower, upper and lateral limits of the illuminating surface, only screens with horizontal or vertical edges shall be used.

Pour déterminer les bords inférieur, supérieur et latéraux du feu, on considère seulement des écrans à bord horizontal ou vertical.




datacenter (1): www.wordscope.ca (v4.0.br)

'screen with vertical edge' ->

Date index: 2022-01-17
w