Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Berceau mobile
Berceau à déplacement transversal
Déplacement transversal d'un électron
Mortaiseuse à déplacement transversal du coulisseau
Râteau mécanique à déplacement transversal

Traduction de «Berceau à déplacement transversal » (Français → Anglais) :

TERMINOLOGIE
voir aussi les traductions en contexte ci-dessous
berceau à déplacement transversal [ berceau mobile ]

glide-out shelf


berceau à déplacement transversal | berceau mobile

glide-out shelf


râteau mécanique à déplacement transversal

traversing mechanical rake [ traversing rake ]


mortaiseuse à déplacement transversal du coulisseau

slotting machine with transverse displacement slide


déplacement transversal d'un électron

transverse displacement of an electron


perpendicularité du déplacement transversal du chariot à l'axe de la pointe vive

squareness of cross slide movement to the spindle axis
TRADUCTIONS EN CONTEXTE
Le service technique doit effectuer, à la satisfaction de l’autorité responsable de la réception par type, un essai visuel pour vérifier que la surface apparente de ces feux n’est pas directement visible par un observateur se déplaçant dans une zone délimitée par un plan transversal situé à 10 m en avant du véhicule, un plan transversal situé à 10 m en arrière du véhicule, et deux plans longitudinaux situés à 10 m de chaque côté du véhicule, ces quatre plans s’étendant de 1 à 3 m au-dessus du sol parallèlement à celui-ci, conformément ...[+++]

The technical service shall, to the satisfaction of the authority responsible for type-approval, perform a visual test to verify that there is no direct visibility of the apparent surface of the exterior courtesy lamps, if viewed by an observer moving on the boundary of a zone on a transverse plane 10 m from the front of the vehicle, a transverse plane 10 m from the rear of the vehicle, and two longitudinal planes 10 m from each side of the vehicle; these four planes to extend from 1 m to 3 m above and perpendicular to the ground as shown in Annex 14 to UNECE Regulation No 48, as referenced in Annex I.


Le service technique doit effectuer, à la satisfaction de l’autorité responsable de la réception par type, un essai visuel pour vérifier que la surface apparente de ces feux n’est pas directement visible par un observateur se déplaçant dans une zone délimitée par un plan transversal situé à 10 m en avant du véhicule, un plan transversal situé à 10 m en arrière du véhicule, et deux plans longitudinaux situés à 10 m de chaque côté du véhicule, ces quatre plans s’étendant de 1 à 3 m au-dessus du sol parallèlement à celui-ci.

The Technical Service shall, to the satisfaction of the authority responsible for type-approval, perform a visual test to verify that there is no direct visibility of the apparent surface of these lamps, if viewed by an observer moving on the boundary of a zone on a transverse plane 10 m from the front of the vehicle, a transverse plane 10 m from the rear of the vehicle, and two longitudinal planes 10 m from each side of the vehicle; these four planes to extend from 1 m to 3 m above and parallel to the ground.


pour la visibilité de la lumière blanche vers l’arrière du véhicule, à l’exception des marquages blancs à grande visibilité apposés sur le véhicule, il faut qu’il n’y ait pas de visibilité directe de la surface apparente d’un feu blanc pour un observateur se déplaçant dans la zone 2 d’un plan transversal situé à 25 m en arrière du véhicule (voir appendice 1);

For the visibility of white light towards the rear, with the exception of reversing lamps and white side conspicuity markings fitted to the vehicle, there shall be no direct visibility of the apparent surface of a white lamp if viewed by an observer moving within Zone 2 in a transverse plane situated 25 m behind the vehicle (see Appendix 1);


f) sauf dans le cas d’un siège d’appoint mis à l’essai avec le dispositif anthropomorphe d’essai précisé à la sous-partie S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012, ne doit permettre à aucun point d’articulation des genoux de passer à travers le plan vertical transversal — lequel plan correspond à la limite de déplacement avant aux figures 5 et 6 de l’annexe 7 — qui est situé à 915 mm en avant du point Z sur le siège normalisé, mesuré le long de la LROS.

(f) except in the case of a booster seat tested with the anthropomorphic test device specified in subpart S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012), not allow either knee pivot point to pass through the vertical transverse plane — shown as the forward excursion limit in Figures 5 and 6 of Schedule 7 — that is 915 mm forward of the Z point on the standard seat assembly, measured along the SORL.


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
e) sauf dans le cas d’un siège d’appoint mis à l’essai avec le dispositif anthropomorphe d’essai précisé à la sous-partie S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012, ne doit permettre à aucune partie de la tête du dispositif anthropomorphe d’essai de passer à travers le plan vertical transversal — lequel plan correspond à la limite de déplacement avant aux figures 5 et 6 de l’annexe 7 — qui est situé à 813 mm en avant du point Z sur le siège normalisé, mesuré le ...[+++]

(e) except in the case of a booster seat tested with the anthropomorphic test device specified in subpart S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012), not allow any portion of the head of the anthropomorphic test device to pass through the vertical transverse plane — shown as the forward excursion limit in Figures 5 and 6 of Schedule 7 — that is 813 mm forward of the Z point on the standard seat assembly, measured along the SORL; and


a) sauf dans le cas d’un ensemble de retenue mis à l’essai avec le dispositif anthropomorphe d’essai précisé à la sous-partie S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012, ne doit permettre à aucune partie de la tête du dispositif anthropomorphe d’essai de passer à travers le plan vertical transversal — lequel plan correspond à la limite de déplacement avant aux figures 5 et 6 de l’annexe 7 — qui est situé à 720 mm en avant du point Z sur le siège normalisé, mesur ...[+++]

(a) except in the case of a restraint system tested with the anthropomorphic test device specified in subpart S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012), allow any portion of the head of the anthropomorphic test device to pass through the vertical transverse plane — shown as the forward excursion limit in Figures 5 and 6 of Schedule 7 — that is 720 mm forward of the Z point on the standard seat assembly, measured along the SORL;


b) sauf dans le cas d’un ensemble de retenue mis à l’essai avec le dispositif anthropomorphe d’essai précisé à la sous-partie S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012, ne doit permettre à aucun point d’articulation des genoux de passer à travers le plan vertical transversal — lequel plan correspond à la limite de déplacement avant aux figures 5 et 6 de l’annexe 7 — qui est situé à 915 mm en avant du point Z sur le siège normalisé, mesuré le long de la LROS;

(b) except in the case of a restraint system tested with the anthropomorphic test device specified in subpart S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012), allow either knee pivot point to pass through the vertical transverse plane — shown as the forward excursion limit in Figures 5 and 6 of Schedule 7 — that is 915 mm forward of the Z point on the standard seat assembly, measured along the SORL; and


a) sauf dans le cas d’un ensemble de retenue mis à l’essai avec le dispositif anthropomorphe d’essai précisé à la sous-partie S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012, ne doit permettre à aucune partie de la tête du dispositif anthropomorphe d’essai de passer à travers le plan vertical transversal — lequel plan correspond à la limite de déplacement avant aux figures 5 et 6 de l’annexe 7 — qui, mesuré le long de la LROS est situé :

(a) except in the case of a restraint system tested with the anthropomorphic test device specified in subpart S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012), allow any portion of the head of the anthropomorphic test device to pass through the vertical transverse plane — shown as the forward excursion limit in Figures 5 and 6 of Schedule 7 — that, measured along the SORL, is


Les valeurs limites de conicité équivalente indiquées dans les tableaux ci-dessous sont calculées pour l'amplitude (y) du déplacement transversal de l'essieu.

The limiting values for equivalent conicity quoted in the tables below shall be calculated for the amplitude (y) of the wheelset's lateral displacement:


Les valeurs limites de conicité équivalente indiquées dans les tableaux ci-dessous sont calculées pour l'amplitude (y) du déplacement transversal de l'essieu.

The limiting values for equivalent conicity quoted in the tables below shall be calculated for the amplitude (y) of the wheelset's lateral displacement:




datacenter (12): www.wordscope.ca (v4.0.br)

Berceau à déplacement transversal ->

Date index: 2021-01-11
w