Traduction de «Contrôle radiographique par rayons X » (Français → Anglais) :

13. Stresses that the technology based on X-ray images emits a high dose of X-rays and should therefore not be considered for systematic screening as far as air safety is concerned;

18. Stresses that every passenger and staff member has the right to refuse a body scan, without the obligation to give any explanation, and the right to request a standard security check, with full respect for the rights and dignity of that person; calls in this regard for all security personnel to receive proper and extensive training; insists that the restriction of use of those scanners which use ionising radiation, for example x-rays, would avoid the need to lay down explicit exceptions for vulnerable persons such as pregnant women, children, handicapped people or people with medical conditions that would render such checks inappro ...[+++]priate;

On the expenditure side, we have managed to make proposals with the potential to curb expenditure in a number of areas, while on the resources side, as a previous speaker indicated – I think it was a Council representative – there will be increases ranging from about 8 to 15% in the final analysis, depending on the items, if I recall the figure that was quoted a short time ago. These, I repeat, are financially judicious positions.

The Regulation states that organic production may be referred to only where the product in question has been obtained and tested in accordance with the rules established therein, and in particular that it contains only substances listed in the Annexes, has not been subjected to treatments involving the use of ionising radiation and has not been made using genetically modified organisms (GMOs) or products derived from these organisms, as this would be incompatible with organic production (Regulation (EC) No 1804/1999).

For two-piece cylinders, and with the exception of welds complying with figure 2A in Appendix 2, the circular butt welds should be radiographed over a length of 100 mm, on one cylinder selected at the beginning and one at the end of each shift period during continuous production and, in the event of production being interrupted for a period of more than 12 hours, on the first cylinder welded.

1. Member States shall ensure that, once the diagnosis of foot-and-mouth disease has been officially confirmed, the competent authority establishes, around the infected holding, a protection zone based on a minimum radius of 3 km and a surveillance zone based on a minimum radius of 10 km. The establishment of zones must take account of natural boundaries and supervision facilities.