Traduction de «Teneur autorisée en composés de plomb » (Français → Anglais) :

In view of the current non-availability of a migration testing method mimicking mouthing conditions, SEAC considered that the restriction should be based on the content of lead in any individual part of jewellery articles, and not on the migration rate of lead released from such articles. In addition, SEAC recommended exemptions to be provided for crystal glass, vitreous enamels, internal components of watch timepieces as well as non-synthetic or reconstructed precious and semiprecious stones.

Where lead, cadmium and antimony (or any of their compounds) are used in the glazes, their content shall not exceed the following specific limits:

When, on imperative grounds of urgency, in particular where a risk to human health exists, the normal time-limits for the regulatory procedure with scrutiny cannot be complied with, the Commission should be able to apply the urgency procedure provided for in Article 5a(6) of Decision 1999/468/EC for the adoption of amendments of the list of extraction solvents which may be used during the processing of the raw materials, of foodstuffs, of food components or of food ingredients, and the specification of their condition ...[+++]s of use and maximum residue limits, and for the adoption of specific purity criteria for extraction solvents, as well as for the adoption of amendments to this Directive when it is established that the use in foodstuffs of any substance listed in Annex I or the level of one or more of the components referred to in Article 3 contained in such substances might endanger human health although it complies with the conditions laid down in this Directive.

In particular, the Commission should be empowered to amend the list of extraction solvents which may be used during the processing of the raw materials, of foodstuffs, of food components or of food ingredients, and the specification of their conditions of use and maximum residue limits, and to adopt specific purity criteria for extraction solvents and the methods of analysis necessary to verify compliance with the general and specific purity criteria as well as methods of analysis and sampling of extraction solvents in and on foodstuf ...[+++]fs.

(24) Whereas Council Directive 85/210/EEC of 20 March 1985 on the approximation of the laws of the Member States concerning the lead content of petrol (9), Council Directive 85/536/EEC of 5 December 1985 relating to crude-oil savings through the use of substitute fuel components in petrol (10), and Article 1(1)(b) and Article 2(1) of Council Directive 93/12/EEC of 23 March 1993 relating to the sulphur content of certain liquid fuels (11), should be repealed accordingly;

This proposal is intended, inter alia, to confirm 1 January 2009 as the date on which all diesel must have a maximum sulphur content of 10 ppm (parts per million); to reduce the polyaromatic hydrocarbon content of diesel to 8% (instead of 11%); to reduce the maximum sulphur content of non-road gas-oil from 1 000 ppm to 10 ppm for land-based uses and from 1 000 ppm to 300 ppm for inland waterways; to increase the oxygenate content and vapour pressure limit for petrol blended with ethanol, in order to enable a higher volume of biofuels to be used in petrol, with appropriate labelling; and to require fuel suppliers to reduce life-cycle ...[+++](refining, transport and use) greenhouse gas emissions from these fuels by 1% per year from 2009.