Traduction de «code de signaux visuels sol-air » (Français → Anglais) :

Ground Air Emergency Code

ground-to-air signalling code [ ground/air signalling code ]

ground/air signalling code

‘signal area’ means an area on an aerodrome used for the display of ground signals.

When visual signals are used to warn unauthorised aircraft flying in or about to enter a restricted, prohibited or danger area by day and by night, a series of projectiles discharged from the ground at intervals of 10 seconds, each showing, on bursting, red and green lights or stars shall indicate to an unauthorised aircraft that it is flying in or about to enter a restricted, prohibited or danger area, and that the aircraft is to take such remedial action as may be necessary.

mandatory checking of all luggage by X-ray or other methods before the passengers are authorized to present themselves at the check-in counter; mandatory verification of passenger identification at the checkpoint and upon embarking; implementation of electronic passenger and employee identification systems; improvement and validation of the system used to control access to restricted areas; RCMP presence in all schedule 1 and 2 airports in Canada; implementation of an emergency intervention plan to counter ground terrorism, which could be customized according to each category of airport; application of legislative measures to counter the ground rage of violent passengers; ground safety inspections of aircraft, which should be done by ...[+++] airline personnel other than flight personnel or aircraft service agents; better control of access to boarding docks or the tarmac, using a system of electronically locked doors to eliminate the need for keys; increased consultation with employees as per the terms and conditions stipulated in part II of the Canada Labour Code; appropriate training for airline personnel provided jointly by Transport Canada and the airline; and the implementation of a safety program, including procedures that can be escalated according to the level of risk.

If available, the following signals in addition to the required freeze-frame information shall be made available on demand through the serial port on the standardised diagnostic connector, if the information is available to the on-board computer or can be determined using information available to the on-board computer: diagnostic trouble codes, engine coolant temperature, fuel control system status (closed-loop, open-loop, other), fuel trim, ignition timing advance, intake air temperature, manifold air pressure, air flow rate, engine ...[+++]speed, throttle position sensor output value, secondary air status (upstream, downstream or atmosphere), calculated load value, vehicle speed, the position of the antilock brake system switch (on/off), the activated default mode(s) and fuel pressure.