Traduction de «ligne de tabulation verticale » (Français → Anglais) :

a surface abutting the end of the strip associated with runway approach 29 consisting of inclined plane having a ratio of one (1) metre measured vertically to fifty (50) metres measured horizontally rising to an intersection with the outer surface, thence said approach surface shall be horizontal and contiguous to said outer surface to an intersection with the southeastern extremity of said outer surface, thence said approach surface shall slope upward ...[+++] at the above specified slope of one (1) metre measured vertically to fifty (50) metres measured horizontally rising to an imaginary horizontal line drawn at right angles to the projected centre line of the strip and distant fifteen thousand (15 000) metres measured horizontally from the end of the strip, the outer ends of the imaginary horizontal line being two thousand four hundred and seventy-five (2 475) metres from the projected centre line; said imaginary horizontal line being two hundred and seventy-one (271) metres, measured vertically, above the assigned elevation of the airport reference point; and

a surface abutting the end of the strip associated with runway approach 11 consisting of an inclined plane having a ratio of one (1) metre measured vertically to fifty (50) metres measured horizontally rising to an intersection with the outer surface, thence said approach surface shall be horizontal and contiguous to said outer surface to an intersection with the northwestern extremity of said outer surface, thence said approach surface shall slope upw ...[+++]ard at the above specified slope of one (1) metre measured vertically to fifty (50) metres measured horizontally rising to an imaginary horizontal line drawn at right angles to the projected centre line of the strip and distant fifteen thousand (15 000) metres measured horizontally from the end of the strip, the outer ends of the imaginary horizontal line being two thousand four hundred and seventy-five (2 475) metres from the projected centre line; said imaginary horizontal line being two hundred and seventy-one (271) metres, measured vertically above the assigned elevation of the airport reference point; and

Being an imaginary surface abutting each end of the strip consisting of an inclined plane having a ratio of one and sixty-six hundredths (1.66) feet measured vertically to one hundred (100) feet measured horizontally rising to an imaginary horizontal line drawn parallel to and ten thousand (10,000) feet measured horizontally from, each end of the strip, thence the approach surface shall rise at a ratio of two (2) feet measured vert ...[+++]ically to one hundred (100) feet measured horizontally to an imaginary horizontal line drawn parallel to, and fifty thousand (50,000) feet measured horizontally from, each end of the strip and located at a height of nine hundred and sixty-six (966) feet above the elevation at each end of the strip, the outer ends of each surface being eight thousand (8,000) feet on each side of the projected centreline as shown on Department of Transport Plans S-424A, B, C, D, E and F dated September 2, 1977.

(c) where in the case of any ship the subdivision load line marks assigned are located below the lowest of the ordinary load lines, the latter load lines, if the owner so desires, need not be placed on the ship’s sides; for such cases the ship’s sides shall be marked with the deck line, the disc, the horizontal line through the centre of the disc, the subdivision load line or lines and the fresh water load line; the fresh water load line mark shall be placed at the same distance above the disc as if the disc were in its normal position; the fresh water mark shall be designated by the letter F at its after end and the forward end of th ...[+++]is load line and that of the subdivision load line or lines shall be connected by a vertical line; the centre of the disc shall be placed at the level of the top edge of the highest subdivision load line; and

(a) an inclined plane at right angles to each strip end and rising therefrom at a ratio of 1 foot measured vertically to 50 feet measured horizontally to an imaginary horizontal line drawn at right angles through the centre line of each strip, as produced, at a point 10,000 feet from each strip end measured horizontally and 200 feet above the elevation at each strip end measured vertically, the outer limits of the said horizontal line being 2,000 feet ...[+++]from the produced centre line; and

4. The Commission may adopt guidelines to ensure full and effective compliance of the distribution system operator with paragraph 2 as regards the full independence of the distribution system operator, the absence of discriminatory behaviour, and that supply activities of the vertically integrated undertaking cannot take unfair advantage of its vertical integration.