Traduction de «translation of dernière injection » (Français → Anglais) :

(b) Capacity of transmission and distribution grids to connect and bring electricity from and to users: This criterion shall be measured by estimating the installed capacity of distributed energy resources in distribution networks, the allowable maximum injection of electricity without congestion risks in transmission networks, and the energy not withdrawn from renewable sources due to congestion or security risks.

Recalls that investment in renewable energy sources represents more than half of all investments in new generation capacity over the last ten years and will continue to grow; emphasises that according a large share of the energy mix to RES entails major challenges for existing network infrastructure, and that investment is necessary to overcome these challenges; notes that, in certain Member States in which the increased feed-in from RES was not accompanied by the development of energy infrastructure, supply security is challenged by such increased feed-in; emphasises that according to ENTSO-E a significant proportion of all the bottlenecks in European energy grids relate to feed-in from RES; emphasises the importance of implementing ne ...[+++]w approaches to overcome bottlenecks in the distribution grids, which do not always entail grid extension and reinforcement; is confident that the benefits of upgrading the European grid, which is equally due to the single electricity market, can offset its costs by offering a much more efficient operation of the EU’s power system; calls on the Transmission System Operators to update their grid development policies in order to cope with the integration of RES generation capacities while maintaining security of supply, and to enhance cooperation with distribution system operators;

(b) Capacity of transmission and distribution grids to connect and bring electricity from and to users: This criterion shall be measured by estimating the installed capacity of distributed energy resources in distribution networks, the allowable maximum injection of electricity without congestion risks in transmission networks, and the energy not withdrawn from renewable sources due to congestion or security risks.

(a)accepts and injects CO streams only if an analysis of the composition, including corrosive substances, of the streams and a risk assessment have been carried out, and if the risk assessment has shown that the contamination levels are in line with the conditions referred to in paragraph 1.

In addition, in accordance with this Directive, the operator of the storage site should only accept and inject CO streams if an analysis of the composition, including corrosive substances, of the streams, and a risk assessment have been carried out, and if the risk assessment has shown that the contamination levels of the CO stream are in line with the composition criteria referred to in this Directive.

accepts and injects CO streams only if an analysis of the composition, including corrosive substances, of the streams and a risk assessment have been carried out, and if the risk assessment has shown that the contamination levels are in line with the conditions referred to in paragraph 1.

In addition, in accordance with this Directive, the operator of the storage site should only accept and inject CO streams if an analysis of the composition, including corrosive substances, of the streams, and a risk assessment have been carried out, and if the risk assessment has shown that the contamination levels of the CO stream are in line with the composition criteria referred to in this Directive.

24 to 28 hours after the last injections, the reactions of the two groups are not significantly different.

Centrifuge for five minutes at 3000 r.p.m. and then remove the supernatant THC solution. Inject the solution into the chromatograph and carry out a quantitative analysis.

1. All new municipal waste-incineration plants must be designed, equipped and operated in such a way that the gas resulting from the combustion of the waste is raised, after the last injection of combustion air, in a controlled and homogeneous fashion and even in the most unfavourable conditions, to a temperature of at least 850 oC at least two seconds in the presence of at least 6 % oxygen.